
I choose to use TEST_SIEC and press EXECUTE. It will be identified after the “Number O” as shown on the graphic below. The file name does not have to be the same as current. First, enter the name of the file under which we want it to be saved. Currently read is marked with To download the program to the data carrier connected to the machine (in this case, the LAN) select F OUTPUT.Īnd now the download procedure. We are now in the machine’s memory and we have a preview of the programs there. Then press the buttons one after another PROGRAM, FOLDER and (OPRT). We switch to EDIT editing mode and enter the program menu PROG. Method on “basic” Fanuc without Manual Guide i.

Downloading a program from a CNC machine to a data carrier, in this example a LAN – step by step To use the appropriate data carrier, it is necessary to set the parameter, which was mentioned HERE. To transfer some data, of course, we need data carrier – it can be a pendrive, PCMCIA card, network, etc. to the CNC machine, is also a key issue and today it will be about the transfer of programs both ways in several ways. So it’s worth to systematically download them. It is a pity if we lose good, well-run programs, in which we put a lot of work. There will always be someone who presses the buttons on the machine faster than reads and thinks. #0552 (baud rate).I know from experience that it is very easy to lose all programs from a machine.

Please, don't change bits that didn't print in the table below #002 (stop bit and data format) bit 0

With help of 'PAGE DOWN' and 'PAGE UP' buttons change bits in the following parameters. After changing parameters below, change this value to 0 again

Set the 'NO PWE' parameter to 1 and press the 'Input' button. Press the button and select the 'Settings 2' submode Set the following parameters on the machine Press the button for parameters settings These settings are for the DNC Precision software only.
